Document scanning for letters, ledgers and bound volumes
Loose letters, ledgers, scrapbooks and bound volumes imaged by hand, with the capture specification agreed in writing and every session checked against targets.
Paper records are the core of most historical collections, and they are rarely tidy. Letters are folded into envelopes with enclosures. Ledgers have tight bindings and writing running into the gutter. Scrapbooks hold clippings, ribbons and loose cards. We image each of them by hand, one page at a time, to a specification you approve before capture starts, and we check the results against measured targets rather than by eye alone.
What we scan
- Letters and loose manuscripts. Each page, plus envelopes, enclosures and anything written on the back. Folds are relaxed only where the paper allows it.
- Ledgers, registers and day books. Captured in page order, with covers, spine and any loose slips recorded where they were found.
- Scrapbooks and albums. Each page as a whole, then folded or hidden items separately, so nothing is lost under an overlapping clipping.
- Bound volumes. Diaries, minute books, letterpress copybooks and printed books, supported throughout capture.
- Newspapers and clippings. Full pages or single clippings, captured at a resolution that keeps small type legible for text recognition.
- Typescripts and carbons. Thin onionskin and carbons need a backing sheet so text from the next page does not show through.
Bound volumes: supported, never forced flat
A bound volume has a safe opening angle, and many older ledgers open to much less than flat. We place each volume in a book cradle that supports both boards at the angle the binding allows, and capture one page at a time where the opening is narrow. Writing that runs into the gutter is captured as far as the binding permits without strain, and we note pages where text could not be reached.
FADGI lists flatbed scanners and vacuum tables as not recommended for rare and special bound volumes, and pass-through document scanners as not recommended for general unbound documents, because they often introduce streak artifacts. We do not put historical originals through a sheet feeder. Glass is used to hold a page flat only where it will not harm the page. If an item starts to crack, tear or flake during capture, we stop and seek a conservator’s advice, as the guidelines direct whenever an original may be harmed.
The capture specification, in writing
Before capture we agree a short written specification for each series: the FADGI category, the target star level, the resolution, bit depth, color space and file formats. The FADGI Technical Guidelines (third edition, 2023) set minimum sampling frequencies by category and star level, including:
| Material | FADGI category | Three-star | Four-star |
|---|---|---|---|
| Rare and special bound volumes (ledgers, diaries, scrapbooks) | 3.1 | 300 ppi | 400 ppi |
| General bound volumes | 3.2 | 300 ppi | 400 ppi |
| Manuscripts and other rare unbound documents | 3.3 | 300 ppi | 400 ppi |
| Unbound documents, general collections | 3.4 | 300 ppi | 400 ppi |
| Newspapers | 3.7 | 300 ppi | 400 ppi |
Resolution alone does not earn a star rating. FADGI rates an image by measuring it against its evaluation parameters (tone, color, sharpness, noise and others) through image analysis of a target. The guidelines also note that color accuracy is measured against the color test target, not the artifact. So we capture to the level agreed in writing and check it against targets, and we describe the work as captured to that level only where the measurements support it.
Higher resolution also means larger files. A letter-size page at 400 ppi is 3,400 by 4,400 pixels, about 44.9 MB of uncompressed 8-bit color. The scanning resolution calculator shows the size for your own originals.
Checking against targets
Each capture session begins by imaging a color and gray-scale target under the same light and settings as the originals. We measure the target images against the tolerances for the agreed star level, and we repeat the check when anything in the setup changes. Then a person views every image for completeness, focus across the page and into the gutter, glare, and fingers or weights over the text, using the points in our image QC checklist. A random sample of each batch is measured in more detail. For a batch of 2,000 images with a 5 percent expected defect rate, 95 percent confidence and a 5-point margin, that sample is 71 images; the QC sample size calculator shows the arithmetic. Recaptured images replace the faulty ones, and every defect is logged.
Example (fictional). Box 3 from the Aster County Historical Society holds 41 Okerlund family letters (96 pages) and the Wren Gulch Mercantile ledger (212 pages). The ledger’s binding opens safely to well short of flat, so it is captured in a cradle under FADGI category 3.1 at three-star, 300 ppi. The letters are captured under 3.3 at three-star, 300 ppi, with their envelopes, and two pencil pages are raised to 400 ppi so faint strokes survive for text recognition. The capture log records the target measurements for each session.
Formats you receive
- Preservation masters in TIFF, the master format the FADGI guidelines list for these categories alongside JPEG 2000, with embedded technical metadata.
- Access copies as JPEG images, and a PDF per item where that suits your users. PDFs become searchable once text recognition has run.
- A capture log with the specification, target results and defects for each batch.
- File names that follow a scheme agreed with you, which the file naming builder can draft.
Format choices follow the Library of Congress Recommended Formats Statement, and the files are packaged with checksums as part of digital preservation.
At the studio or on site
Most boxes travel to our studio in Colorado Springs, with the chain of custody described on the collection care page. We can work on site when originals cannot travel. Oversize maps and plans go to large-format scanning, and photographs found in a box of papers are captured as described under photo and negative scanning, in the same pilot.
Send one box first.
A pilot box shows you the images, the recognized text and the catalog records before you commit a whole collection. Tell us what is in the box and what you want people to find.
Studio and contacts
24 South Weber Street, Suite 225Colorado Springs, CO 80903(719) 244-8450sales@dastok.com